There are too many
or too little shots
compared to what
was programmed
and the cycle
detection error code
does not appear
The sector gear is too close
to the sensor line or the gear
is too dirty and prevents
proper readings.
Unscrew the unit, move it to the right as far
as possible and screw it back again.
Clear the sector gear of excess grease.
External magnetic
field error appears,
despite no external
magnet being close
to the replica
Trigger was being held at
startup.
Reconnect the battery and do not hold the
trigger during the startup.
The trigger has too much
slack and can move
sideways, which can activate
the error.
Shim the trigger so that it cannot move
sideways, only back on forth.
The triggers movement is
obstructed and when it is
released, it may end up in
slightly different positions. If
at some moment the trigger
will move further back than
it was at startup, this can
activate the error.
Make sure the trigger can move freely and
completely unobstructed.
Use stronger trigger spring.
When RoF reduction
is enabled,
electronic fuse
activates or the
replica just does not
shoot
The RoF reduction is too
great and the motor is not
able to cycle the gearbox.
Reduce RoF reduction or disable it
completely.
In SR25 with 19-
teeth gears, active
brake and/or spring
drop does not work
properly (the piston
remains precocked)
Due to additional teeth, the
cycle is detected too early.
Perun brakes the gears fast
enough to stop the sector
gear just before it can
release the piston to make a
shot.
Enable precocking on a low level and check,
whether the cycle ends where it should –
with the piston in front position. Spring drop
may still not work and this method should
be used instead to release the spring. If you
want to have precocking during play, we
advise to set high precocking for the game
on semi, and low precocking on auto only for
dropping the spring.
Attention! In case of any technical questions, please contact us at: info@perunairsoft.pl
To Next Page
Loading...
Need help?
General