5
3. During the start-up
Every time, when connecting the battery to the replica, make sure that the selector is set to “SAFE”.
This is a safety concern, but it also helps Perun find out, where the “SAFE” position is. If you will connect
the battery with the selector on “SEMI” or “AUTO”, the replica may not shoot unless you switch to
“SAFE” first or even if it does, the unit may sometimes function abnormally until the “SAFE” position is
reached at least once.
4. Adaptive trigger control
Each time the battery is connected, Perun senses the trigger resting position and uses it as a reference
(therefore, make sure to never pull the trigger during startup). Depending on the current trigger
sensitivity setting, Perun will automatically fire after the trigger has traveled a long enough distance.
This allows very short trigger pulls with no trigger modification needed whatsoever and the trigger
sensitivity changes possible even in the field.
When using a trigger with regulation, only the overtravel limiter should be used. Pre-travel regulation
can make the trigger pull necessary to fire a shot longer, than it would have been when left in the
standard forward position. When in normal semiautomatic mode, the Perun Hybrid uses a progressive
trigger activation method. This means that the trigger threshold and reset points are mobile and move
together with the trigger, as shown on the sketch below:.
This results in two things:
1. If high trigger sensitivity is set, in most cases (depending on the trigger model) you should be
able to pull the trigger all the way back and shoot by only slightly releasing it from the rearmost position
and pulling it again. It also allows to easily “spam” in the semiautomatic mode because you only need
to quickly pull the trigger, not necessarily having to make sure it is fully released. This might be a point
of interest, particularly for speedsoft players.
2. For players looking for more realism, what might be important is that the trigger must always
be reset (released) a certain distance before another shot can be taken, which is noticeable at lower
sensitivities. This emulates how triggers in real firearms work and provides a greater degree of control.
The progressive method does not work when burst, auto, DMR mode, binary trigger or 2-stage trigger
are enabled.
To Next Page
Loading...
Need help?
General