2
1. Technical data
Recommended power sources
Perun V2 Hybrid works with any power source that provides a voltage between 7 and 17 volts and can
deliver enough current to ensure smooth cycling of the replica. Li-Po and Li-Ion batteries with a
nominal voltage of 7.4, 11.1 or 14.8 volts are recommended. It is also advised to use batteries with
possibly high „C” parameter and capacity. This is safer for the battery, as it should not be working on
the edge of its capability. In this video, we are showing why:
https://www.youtube.com/watch?v=s8RKcIy810A
Capacity and the „C” parameter also influence the rate of fire of the replica:
https://www.youtube.com/watch?v=5hO25aPvHcU
Compatibility with high-ROF and high-power builds
Perun V2 Hybrid can work with any replicas, including highly tuned.
Compatible gearboxes, gears, and triggers
Perun V2 Hybrid works both in airsoft electric replicas and gel blasters. It is designed to fit version 2
gearboxes in Tokyo Marui standard.
Gearbox color or its “shininess” has no effect on the operation of Perun V2 Hybrid.
Perun V2 Hybrid was successfully tested in and should fit without the need for any modification in
gearboxes made by the following manufacturers: A&K, Bolt, Classic Army, G&G (with exceptions), G&P,
ICS, JG, King Arms, KWA (gen 2.0, 2.5+ and 3.0+), Retro Arms, Specna Arms, Ultimate, and VFC. Some
grinding of the contacts area is needed in Cyma, G&G G2 and Krytac gearboxes (see page 13). KWA
ERG replicas are not compatible. These are gearboxes that we tested for compatibility during the
design process. Please be advised, that despite our best efforts to provide reliable information, we
cannot guarantee full compatibility for all the gearbox shells mentioned above. Replica manufacturers
sometimes slightly change dimensions of their parts from batch to batch, bringing need for some
adjustment or in extreme cases, making them incompatible with Perun V2 Hybrid.
Perun V2 Hybrid works with any gearset, including DSG, short stroked, helical, non-helical, and with
any ratio. The only exception are 32:1 gears, that work with “half-teeth” pistons. 19-teeth sector gears
(used in SR25 replicas) might need some special handling when it comes to use of spring drop feature.
Stock and aftermarket triggers in Tokyo Marui standard can be used with Perun V2 Hybrid. Trigger
color does not affect the operation. Some ICS triggers might require dremelling before magnet holder
can be placed on them. G&G ETU triggers are incompatible and should be replaced.
Electronic fuse
Perun V2 Hybrid has an integrated electronic fuse, which will automatically cut the power off in case
of a short circuit or when a gearbox jam is detected. The fuse does not wear out when it is activated.
Battery connector type
Perun V2 Hybrid comes with an already soldered T-Plug connector (T-Deans).
Soldering pads for gel blasters and tracer hop-up chambers
There are two soldering pads on Perun’s electronic board, designed especially for soldering the mag
terminals’ wires or tracer hop-up chamber wires to them.
To Next Page
Loading...
Need help?
General