Peruzzo TB100 - Safety Controls and Switches

TB 100
PAG. 10 Cod. 29050055 Rev.01 Edit: 09/2015
3.4 Safety controls and switches
3.4.1a Emergency Stop (Fig 3.4.1a)
In the event of an emergency, push the STOP button. This will lock in position
to stop the engine and the machine.
3.4.1c Emergency Stop (Fig 3.4.1c)
In the event of an emergency, push the lever shown on the figure in order
to stop the chipper running.
3.4.1.1 Once the emergency has been rectified, the following sequence should be
carried out:
3.4.1.2 Check over the machine for any blockages.
3.4.1.3 To reverse the cutter, remove the drive guard, and, using a bar through the hole
in the cutter spindle, manually turn the cutter to free the obstruction
(See Section 5, Fig. 5.3a)
3.4.1.3c In the hydraulic engine version, in order to reverse the cutter push the lever as
shown on Fig. 3.4.1c
3.4.1.4a After clearing the blockage, pull the STOP button out and restart the engine.
3.4.2 Engine stop switch
3.4.2.1 To stop the engine, push the cut-off switch to the ‘0’ position (Fig 3.4.2), or
(electric start) turn the key switch anticlockwise.
CAUTION! Do not restart the engine until the hazard has been removed.
Fig. 3.4.3 Infeed chute height
Infeed chute
height 600 mm