Peruzzo TB100 - Safe Operating Practices

TB 100
PAG. 9 Cod. 29050055 Rev.01 Edit: 09/2015
3.3 ALWAYS:
3.3.1 Check the machine before starting up (see Section 4 Preparation and Section
5.1 Operation: Pre-work checks).
3.3.2 Be aware of potential hazards in the work area, i.e. uneven ground, tree roots,
trip/slip hazards, obstructions and type of materials being fed into the machine.
3.3.3 Feed from the side.
3.3.4 Keep clear of the discharge area.
3.3.5 Have a second trained operator within easy reach of the machine.
3.3.6 Maintain strict discipline at all times.
3.3.7 Service machine at the specified periods (see Section 6: Routine Maintenance).
3.3.8 Note direction of the discharge chute, and, if necessary, note the wind direction to
prevent debris from being blown into a highway, or where it could affect members
of the public.
3.3.9 Remove the ignition key before doing any maintenance.
Fig. 3.4.1a STOP button Fig. 3.4.2 Engine switch-off
Fig. 3.4.1c STOP and START-levers
STOP
button
Engine
switch-off
Stop
start return