Peruzzo TB100 - Blade Servicing and Adjustment

TB 100
PAG. 21 Cod. 29050055 Rev.01 Edit: 09/2015
6.7.4b Place the stand under the cassette.
6.7.5b Lower the machine onto the cassette
stand.
6.7.6b Remove 2 front bolts and 2 rear
bolts.
6.7.7b Carefully raise the machine to
release the cassette.
6.7 Blade servicing
CAUTION! Take proper care.
The blades are extremely sharp.
6.7.8 Slacken the blade bolts and remove
them.
6.7.9 Turn the blades round and refit so
that the opposite edge is used.
6.7.10 Tighten the blade bolts to 35Nm.
6.7.11 Check that the clearance to the anvil
is 0.5 mm with the aid of the gauge
supplied. Fig. 6.7.3 - Fig. 6.7.4 -
Fig. 6.7.5
Note: If the blades have been reground,
the anvil will need readjusting to
0.5 mm
6.7.12 Reassemble the cassette and refit to
the machine by reversing the
procedure described above.
6.7.13 Refit the belts as referred to in
section 6.5 above.
6.7.14 Replace and secure the drive guard.
6.7.15 Check the counter-blade for wear and
have it reversed, if necessary, to
acquire a brand-new cutting edge. To
access the counter-blade,
disassemble the infeed chute
(Fig. 6.7.5) and remove the bolts from
under the cutting unit (Fig. 6.7.6).
Fig. 6.7.3
Fig. 6.7.4
Blade calibration
0.5 mm
Fig. 6.7.5
Counterblade
Counterblade
bolts