Programming Guide V4.1 OT-300 Page 1 of 5 ©20101Perimeter Technologies, Inc
Mini Receiver Code
Three Button Design
The up or down buttons are used to
increase or decrease the menu selections or
to increase or decrease the setting within
each menu. The center button is used to
select a menu option or setting within each
menu.
The Menu of Settings
The OT-300 includes a menu of settings to program each receiver that include:
Programming Guide – V 4.2
OT-300 Transmitter
EcoLite, Rechargeable Receiver Code
• Signal Field Width – variable settings from 0 to 32 feet
• Receiver Sensitivity
– used to help match receivers to a boundary
• Frequency (10)
– four settings to help avoid interference from
neighboring systems or ground loops
• Warning time (20)
– four settings to fix the time prior to the correction
• Correction Modes (30)
– choose from four standard levels or three
progressive levels to customize a correction that is right for each pet
• Duration (40)
– (for progressive correction levels) – four settings to
adjust the time between progressing corrections
• Power Cycling (50) – two settings
• Modulation Frequency (60)
– six different frequencies to mimic
competing pet containment systems
• Stopper Mode (70)
– four settings to adjust the amount of time before
correction stops
• GentelSteps™ (80)
– nine levels of correction for a slow and gentle
approach to learning new boundaries
Questions on programming should be directed to Technical
Support @ 888.392.2007 x 1751
To Next Page
General
