8
❶ Install the
contact points
❸ Tighten the static
stimulation column
with the test light
❷ As wrench
Tips: Please fully charge the product before use
Contact the magnetic charging cable port with the charging port,
and the product can be charged once they are adsorbed to each
other.
Red light means on charging
Green Light means product
fully charged
Protection mode
The product enters the 1min
protection mode after every 6 times
of correction, the screen displays
P and beeps, and this mode lasts
for one minute to enter the next
cycle
⑫
2.Charging
3.Installation
To Next Page
Loading...