6.Important Notice
7.Summary of Frequently Asked
Questions
1. The display of transmitter stays on for approximate 6 seconds
after a button press.After 6 seconds with no button press,the
blue backlight shuts off first, and if no button press with another
50 seconds,the display shuts off and the transmitter goes into
sleel mode with atuto-vibration,pressing any button with auto-
vibration will turn the display back on.
2.The receiver will be into shallow sleep mode if stop working for
5 seconds,and if without any operation for 50 seconds,it will be
into deep sleep mode, Any commands from the transmitter will
activate the receiver.
3.Press"A B"button for selection. Channel A controls the first
receiver and Channel B controls the second receiver. Channel
A B controls both the two receiver.
4. The design of the receiver is rainproof. The rubber cover
has to be put in the right position to ensure rainproof effect.
5. Test static stimulation function
1) Place the Test bulb to the metal screws (ensure the mental
points are attached when test the stimulation function).
2) Press the “Static Stimulation" button, and the LED light will
flash on.
6. How to find the bestVibration/Stimulation Level?
The level of Vibration/Stimulation best suited for your dog
depends on your dog's temperament and threshold for
Vibration/Stimulation. Always start at the lowest level and work
your way up.The appropriate level can be found when the dog
responds to the Vibration/Stimulation with a mild reaction, such
as a tensing of the neck muscles. The Vibration /Stimulation
Level may vary depending on the training situation. When
highly distracted, dogs will require a higher level of
Vibration/Stimulation
Is the Vibration/Stimulationsafe for my pet?
While the Vibration/Stimulation is unpleasant, it is
harmless to your pet. Electronic training devices
require interaction and training from the owner to
achieve desired results.
Q
A
How old does my pet have to be before using the
Remote Training Collar?
Your pet should be able to recognizebasic
obedience commands such as “Sit” or “Stay”.
Pets should be at least 6 months old before using
the Training Collar.
Q
A
Once my pet is trained and has been obeying my
commands,will he have to continue to wear the
Receiver Collar?
Probably not. You may need to reinforce training
with the Receiver Collar from time to time.
Q
A
Is the Receiver Collar waterproof?
It's water resistant/rainproof. Be sure to keep the
rubber cover put in the right position and do not
make the dog swim in water.
Q
A
How long can I continuously deliver Vibration/
Stimulation to my pet?
The maximum amount of time you can press the
Stimulation Button and deliver Stimulation to your
pet continuously is 5 seconds. And the maximum
amount of time you can press the Vibration Button
and deliver Vibration to your pet continuously is
10 seconds After this, Vibration/Stimulation cannot
be delivered until You release and press the
button again.
Q
A
How long should I process my training session for
my pet?
Training sessions should be kept positive and
short ,it is better for about 10-15 minutes each
time.
Q
A
8.FCC Compliance
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
-7- -8-
To Next Page
Loading...