EasyManua.ls Logo

Peterbilt 520 - Page 161

Peterbilt 520
276 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Every 30,000 mi / 48,000
km
Every 30,000 mi / 48,000 km
17
Front Suspension - Spring Pins
Lubricate with approved grease. (Refer to Front Axle and Suspension on page 224 for maintenance instructions.)
Drive Axle - Linehaul (PACCAR) - Axle Assembly
Check oil level and inspect for leaks.
Visually inspect for damage or leaks.
Drive Axle - Linehaul (PACCAR) - Breather
Check the operation. If the cap doesn't rotate freely, replace.
Drive Axle - Vocational (PACCAR) - Axle Assembly
Drain and replace MINERAL BASE lubricant.
Drive Axle (Meritor Line Haul / ON HIGHWAY) - Axle Housing
Check the "cold" fill level at the differential carrier plug for a pinion angle of less than 7 degrees, or at the axle bowl plug for a
pinion angle of greater than 7 degrees. Tighten the plug to 35-50 lb-ft (47-68 N·m.) (Refer to Drive Axle - Meritor on page 234
for maintenance instructions.)
Visually inspect for damage or leaks. (Refer to Drive Axle - Meritor on page 234 for maintenance instructions.)
17
Ensure that all maintenance intervals leading up to this point are repeated during this interval prior to the completion of
MAINTENANCE - Every 30,000 mi / 48,000 km
those listed here.
Y53-6096-1C1 (09/20) 161
5
https://www.besttruckmanuals.com/

Table of Contents

Related product manuals