Need help?Do you have a question about the Peterbilt 348 2017 and is the answer not in the manual?
Provides information for safe and efficient operation and maintenance.
Details safety procedures for entering and exiting the cab and accessing the deck plate.
Covers operation and safe use of vehicle seats and restraint systems.
Outlines procedures for preparing the vehicle for road use.
Provides guidance on responding to various vehicle issues and emergencies.
Explains the introduction and procedure for jump starting vehicles.
Covers vehicle recovery guidelines and procedures for spring brakes.
Describes the dash with standard gauges and switches, noting location variability.
Covers standard warning lights and audible alarms that indicate system malfunctions.
Explains the display located at the top of the instrument cluster showing vehicle information.
Introduces descriptions of various gauges on the instrument panel.
Covers controls located on the steering column, including tilt/telescoping features.
Lists controls found on the dash and doors, such as ignition and hazard flashers.
Covers normal weather starting, cold weather starting, and engine warm-up.
Details stationary PTO operation, engine fan control, winterfronts, and engine control display.
Introduces manual and automatic transmissions, putting the vehicle in motion, and auxiliary transmissions.
Covers introduction to brake systems, hydraulic brakes, retarders, and parking brake.
Details the cruise control switch and its operation.
Explains differential lock and dual range rear axle operation.
Covers setting ride height for rear air suspensions.
Covers driving tips like coasting, descending grades, engine overspeed, and fuel consumption.
Provides procedures for stopping the engine, including turbocharger cooling and refueling.
Introduces the preventive maintenance program and its importance for vehicle operation and warranty.
Provides basic information for routine lubrication requirements and warns about handling lubricants.
Covers introduction, air dryer, air tanks, gauges, and air compressor maintenance.
Details brake adjustment procedures.
Discusses exterior maintenance, cleaning, weather stripping, safety restraint inspection, and windshield wipers.
Covers cooling system maintenance and engine block heater.
Details electrical system, light bulbs, fuses, circuit breakers, relays, battery care, and remote keyless entry.
Covers engine maintenance, lubrication, drive belts, fan, and air intake system.
Covers fuel shut-off valves, specifications, and fuel filters.
Provides an introduction to frame maintenance and welding precautions.
Covers axle lubrication, inspection, wheel alignment, and U-bolt torque.
Details heater and air conditioner introduction, air filters, heater, and air conditioner maintenance.
Discusses general maintenance, visual inspection, rear suspension fasteners, axle lubrication, and alignment.
Covers power steering maintenance, fluid level, and filter replacement.
Details driveshaft maintenance and U-joints.
Covers tire maintenance, checking inflation pressure, and matching tires.
Explains wheel bearing adjustment.
Covers introduction to transmissions, oil changes, and clutch system.
Covers vehicle identification, VIN information, and component identification.
Discusses federal safety standards, ordering parts, NHTSA consumer info, Canadian info, and warranty.
To Next Page
General
