Every 60,000 mi / 96,000 km / 6 Months
18
Electrical and Lights - Alternator
•
Check operation and output. (Refer to Alternator on page 214
• Check tightness of the pulley nut. (Refer to Install Engine Belt on page 217 for maintenance instructions.)
• Check the tension of the drive belt. (Refer to Install Engine Belt on page 217 for maintenance instructions.)
• Check tightness of the terminal hex nuts. (Refer to Install Engine Belt on page 217 for maintenance instructions.)
Electrical and Lights - Starter
• Check torque on hex nuts. (Refer to Electrical System on page 206 for maintenance instructions.)
Electrical and Lights - ECM Connector
• Check the tightness of the ECM connector. (Refer to Electrical System on page 206 for maintenance instructions.) for
maintenance instructions.)
Electrical and Lights - Wheel Sensors
• Check for damaged sensors and connectors, and worn or frayed wires. (Refer to Electrical System on page 206 for
maintenance instructions.)
Electrical and Lights - Power Supply Harnesses (engine, Transmission, etc.)
• Check for worn or damaged insulation, corroded terminals, frayed. Wash to remove excess grease. (Refer to Electrical System
on page 206 for maintenance instructions.)
For Cab Structure, Doors and Hoods - Hinges and Latch
• Lubricate with silicone spray.
18
Ensure that all maintenance intervals leading up to this point are repeated during this interval prior to the completion of
those listed here.
MAINTENANCE - Every 60,000 mi / 96,000 km / 6 Months
172 Y53-6096-1C1 (09/20)
5
https://www.besttruckmanuals.com/
To Next Page
Loading...
