EasyManua.ls Logo

Peterbilt 520 - Page 166

Peterbilt 520
276 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Every 60,000 mi / 96,000 km / 6 Months
18
Front Suspension U-bolts - U-bolts (ON HIGHWAY)
Check the general condition and the tightness of the nuts. Tighten the nuts to the specified torque value as required. (Refer to
Suspension U-Bolts, Grade 8 on page 251 for maintenance instructions.)
Front Suspension U-bolts - U-bolts (VOCATIONAL)
Check the general condition and the tightness of the nuts. Tighten the U- bolts after the first day or two of operation. Then
tighten the nuts to the specified torque value as required. (Refer to Suspension U-Bolts, Grade 8 on page 251 for maintenance
instructions.)
Drive Axle - Linehaul (PACCAR) - Axle Assembly
Drain and replace MINERAL BASE lubricant.
Drive Axle (Dana) - Axle Housing
Visually inspect for damage or leaks. (Refer to Drive Axle - Dana on page 233 for maintenance instructions.)
Check oil level. Check "cold." Torque the drain plug. (Refer to Drive Axle - Dana on page 233 for maintenance instructions.)
Drive Axle (Dana) - Air Shift Unit
Check the lubricant level. (Refer to Drive Axle - Dana on page 233 for maintenance instructions.)
Drive Axle (Dana) - Lube Pump (OFF HIGHWAY)
Remove the magnetic strainer and inspect for wear particles. Wash in solvent and dry in air. (Refer to Drive Axle - Dana on
page 233 for maintenance instructions.)
Drive Axle (Dana) - Lube Filter (OFF HIGHWAY)
Change. (Refer to Drive Axle - Dana on page 233 for maintenance instructions.)
18
Ensure that all maintenance intervals leading up to this point are repeated during this interval prior to the completion of
those listed here.
MAINTENANCE - Every 60,000 mi / 96,000 km / 6 Months
166 Y53-6096-1C1 (09/20)
5
https://www.besttruckmanuals.com/

Table of Contents

Related product manuals