EasyManua.ls Logo

Peterbilt 520 - Page 177

Peterbilt 520
276 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Every 120,000 mi / 192,000 km / Annually
19
Rear Suspension - Frame and Crossmembers Bolts
Check the torque. Tighten to specified torque value as required. (Refer to Rear Axle and Suspension on page 231 for
maintenance instructions.)
Rear Suspension - Mounting Brackets and Fasteners
Check the condition and the fastener torque. Tighten to the specified torque value as required. (Refer to Suspension U-Bolts,
Grade 8 on page 251 for maintenance instructions.)
Hub, Drum, and Hubcap - Hubs (non-LMS) with Standard Seals
Clean the components and check for excessive wear or damage. Change the oil and seal. (Refer to Wheels on page 242 for
maintenance instructions.)
Cooling - Extended Life Coolant (ELC)
Perform lab analysis. If lab analysis shows coolant is unsuitable for continued use: Flush, drain, and refill. Add ELC Extender.
(Refer to Cooling System Maintenance on page 198 for maintenance instructions.)
Power Steering - Reservoir (ON HIGHWAY)
Drain, replace the filter, and refill. (Refer to Power Steering Fluid on page 237 for maintenance instructions.)
Steering Components - Steering Linkage
Check all joints for excessive lash: replace as required. (Refer to Steering System on page 236 for maintenance instructions.)
Fuel and Tanks - Fuel Tank Breathers
Check for proper function: clean the drain hoses. (Refer to Fuel Tank on page 222 for maintenance instructions.)
19
Ensure that all maintenance intervals leading up to this point are repeated during this interval prior to the completion of
MAINTENANCE - Every 120,000 mi / 192,000 km / Annually
those listed here.
Y53-6096-1C1 (09/20) 177
5
https://www.besttruckmanuals.com/

Table of Contents

Related product manuals