10
Please visit the page
petratools.com/support/HD101
Questions/ Issues with
your product?
We’ll make it right
1-800-613-6889
support@petratools.com
www.petratools.com
Problem: The spray is weak or intermittent
Possible Causes and Solutions:
• Clogged Filters: Check and clean the filters inside the valve handle and at the
bottom of the hose inside the tank.
• Low Pressure: Pump the unit to build more pressure.
• Nozzle Clog: Inspect the nozzle for clogs and clean it with water and a soft brush.
• Seal and Connections: Ensure all seals and connections are tight.
Problem: The liquid is not being drawn from the tank
Possible Causes and Solutions:
• Pickup Tube: Ensure the pickup tube inside the tank is properly connected
and not damaged.
• Liquid Level: Verify that there is sufficient liquid in the tank.
• Clogged Filters: Check and clean the filters inside the valve handle and at the
bottom of the hose inside the tank.
1.
Remove the Pump: First, remove the pump
assembly from the tank.
PUMP INSPECTION
Lubricate the O-Ring: Apply a small amount of silicone or
Teflon-based lubricant to the O-ring at the base of the
pump handle.
4.
Unscrew the Orange Nut: Unscrew the orange nut
securing the orange pump handle to the black pump
housing.
2.
Slide Out the Pump Handle: Carefully slide the pump
handle out of the pump housing.
3.
Reassemble the Pump: Slide the pump handle back into
the pump housing, screw the orange nut back on, and
then reattach the pump assembly to the tank.
5.
Problem: The unit is hard to pump
Possible Causes and Solutions:
Pump Assembly: Inspect the pump assembly for damage or wear.
To Next Page
