3. When the LED
turns blue, release
the power button
and then hold the
test light tool to
the collar’s
contact points.
After a 2-second
delay, the bark
collar will be in
test mode. For
each level, the collar will beep and the test light tool will
flash (level 1 = 1 beep and 1 flash, level 2 = 2 beeps and
2 flashes, etc.).
4. When the test is complete, the bark collar will beep high to
low and turn itself off. You can stop the test at any time by
pressing the power button.
Test the
bark collar.
If you are certain you have fit the bark collar properly to your
dog but it still doesn’t seem to be working, complete the
following steps to test the bark collar. You will need the test
light tool (see page 3).
1. With the bark collar charging, press and hold the
power button.
2. Continue to hold the power button while disconnecting the
bark collar from the charger.
9
To Next Page
Loading...
