www.petsafe.net 5
Panel Pet Insert Door
Flap Replacement/Horizontal Flap Adjustment: The PetSafe
®
Panel Pet Door Insert uses two
Large PetSafe Replacement Flaps. To replace a ap, simply hold ap up and unscrew the ve screws
on the back side of the Hinge Plate. Replace with a new ap and reinstall the existing ve screws to
secure ap back into place. To horizontally adjust a ap, hold ap up and loosen the ve screws on the
backside of the Hinge Plate. Adjust ap left or right for a snug t and tighten screws back into place.
Vertical Flap Adjustment: To adjust ap vertically the Interior or Exterior Cover plate will need to be
removed, depending on which ap is being modied. Use a small at head screwdriver to remove
Finishing Plugs on the Interior or Exterior Cover. Loosen the ve screws on the upper section of the
Hinge Plate and adjust ap up or down for a snug t. Tighten screws back into place and replace
Finishing Plugs.
NOTE: Vinyl flaps shrink during cold months and stretch in warmer months and may need to be
adjusted to ensure a proper fit during seasonal changes.
Terms of Use and Limitation of Liability
1. Terms of Use
This Product is offered to you conditioned upon your acceptance without modication of the terms,
conditions and notices contained herein. Usage of this Product implies acceptance of all such terms,
conditions, and notices.
2. Proper Use
This Product is designed for use with pets where training is desired. The specic temperament of your pet
may not work with this Product. If you are unsure whether this is appropriate for your pet, please consult your
veterinarian or certied trainer. Proper use includes reviewing the entire Operating Guide provided with your
Product and any specic Caution statements.
To Next Page
Loading...
