中文
EN
19www.petsafe.cn
Key Definitions
Contact Points: Deliver the
static correction.
Sensor Probe: Detects the vibrations of
your dog’s barking. Note: The Sensor Probe
is not adjustable.
Battery: Turns the unit on when installed.
Low Battery Indicator: The Indicator
Light will begin flashing when battery is low.
Fit the Bark Control Collar
Important: The proper fit and placement of your Bark Control Collar is important for effective
operation. The Contact Points must have direct contact with your dog’s skin on the underside of his neck.
To assure a proper fit, please follow these steps:
1. Make sure that the battery is not installed in the Bark Control Collar.
2. Start with your dog standing comfortably (A).
3. Place the Bark Control Collar on your dog’s neck close to the ears. Center the Contact Points
underneath your dog’s neck, touching the skin (B).
You may need to trim the hair in the area of the Contact Probes. Never shave the
dog’s neck; this may lead to a rash or infection..
4. Check the tightness of the Bark Control Collar by inserting one finger between the end of a Contact
Point and your dog’s neck (C). The fit should be snug
but not constricting.
5. Allow your dog to wear the Bark Control Collar for
several minutes then recheck the fit. Check the fit again
as your dog becomes more comfortable with the Bark
Control Collar.
BATTERY 6V
RFA-67
Battery
Contact Points
Washers
Sensor Probe
Low Battery
Indicator Light
BA
C
To Next Page
Loading...
