中文
EN
20 Customer Care Center +86 (0) 755 2671 5353
You should not make the collar any more tight than is required for good
contact. A collar that is too tight will increase the risk of pressure necrosis in the
contact area.
6. Trim the collar as follows (D):
a. Mark the desired length of the Bark Control
Collar with a pen. Allow for growth if your dog is
young or grows a thick winter coat.
b. Remove the Bark Control Collar from your dog
and cut off the excess.
c. Before placing the Bark Control Collar back onto
your dog, seal the edge of the cut collar by applying a flame along the frayed edge.
The Bark Control Collar should not be worn for more than 12 hours out of every
24-hour period. Leaving the Bark Control Collar on too long could lead to skin
irritation. Please refer to page 16 for additional information.
Care and Cleaning
• Your dog’s neck and the Contact Points must be washed weekly with a damp cloth.
• Be sure that your pet’s neck is thoroughly dry before placing the Bark Control Collar back on
his neck.
Risk of skin damage.
• For comfort, safety and effectiveness of this product, please ensure that you check the fit
of your pet’s collar frequently. If any skin irritation is observed, discontinue the use of the
collar for a few days. If the condition persists beyond 48 hours, see your veterinarian.
• Do not attach a lead to the collar. This can result in pulling the Contact Points too tightly
against your pet’s neck. Attach a lead to a separate, non-metallic collar or harness,
making sure the extra collar does not put pressure on the Contact Points.
D
To Next Page
Loading...
