Petwa 75V - Salt Level Management; Warranty and Maintenance Information Recording

22
Sodium
Water
Checking the Salt Level
Check the salt level monthly. Remove the lid from the cabinet or brine tank, make sure salt level is always above the brine level.
Add Salt to the Brine Tank
Put 40 kgs of crystal water softener salt in the brine tank. The unit will automatically ll the water to the correct level when it
regenerates. Use only clean salt labeled for water conditioner use, such as crystal, pellet, nugget, button or solar. The use of rock
salt is discouraged because it contains insoluble silt and sand which build up in the brine tank and can cause problems with the
system’s operation. Add the salt directly to the tank, lling no higher than the top of the brine well.
NOTE :THE WATER LEVEL SHOULD BE BELOW THE SALT LEVEL ALL THE TIME
CAUTION!
Incorrect start up, water
above the salt level, (not
enough salt in tank) will both
effect the units capacity and
result in hardness slippage.
Should either of these situa-
tions happen or the unit fails
to regenerate for any other
reason please first correct
the problem. Then regen-
erate the unit manually 2
times in a row to restore the
reserve capacity and bring
the media bed back up to
specification.
IMPORTANT WARRANTY AND MAINTENANCE INFORMATION
Model number:
Serial number:
Valve Serial number:
Date installed:
Please have the information below lled out and available when calling in for parts or warranty:
Additional notes:
___________________________________________________________________
___________________________________________________________________
___________________________________________________________________
___________________________________________________________________
___________________________________________________________________
___________________________________________________________________
MAINTENANCE INSTRUCTIONS AND SCHEDULE