Never fill past this mark.
According to the information given in
In all cases, the oil selected must meet
the manufacturer’s requirements.
the coolant does not need to
Use the fluid recommended by the
When the engine is warm, the tem-
perature of the coolant is controlled
by the engine fan. This fan can oper-
ate with the ignition off.
In the case of vehicles fitted with
a particle emission filter, the fan
can operate after the vehicle has
stopped, even when the engine is
In addition, as the cooling system is
pressurised, wait for at least one hour
after the engine has stopped before
Slacken the cap by two turns to re-
lease the pressure to prevent any
risk of scalding. When the pressure
has dropped, remove the cap and
Diesel additive level (Diesel
with particle emission filter)
If the service warning light comes on,
accompanied by a message and an
audible signal, this indicates a low
This additive must be topped up.
Contact a PEUGEOT dealer as soon
To maintain the reliability of
engines and emission control
systems, the use of additives
in engine oil is prohibited.
The level should always be
Remove the style trim* (see §
“Changing a bulb - Front lights”).
Open the reservoir, with the engine
at ambient temperature. The level
should always be above the MIN.
mark and close to the MAX. mark.
For best quality cleaning and
for your safety, we would ad-
vise that you use products
Check the level regularly and
top up between changes. The
maximum consumption is 0.5 l
per 600 miles (1 000 km).
Check the level with the ve-
hicle level, engine cold, using the oil
level gauge on the instrument panel
ried out according to the
the manufacturer, which fulfil DOT4
To Next Page
Loading...
Need help?
General
