PEUGEOT 407 User Manual

10
10
118
CHANGING A FRONT BULB
Handle the bulbs with a dry cloth.
2 - Main beam headlamps:
H7-55 W.

Remove the protective cover corre-
sponding to the faulty bulb.

Disconnect the connector.

Press the end of the securing clips
to free the bulb. Change the bulb.

When fitting the new bulb, ensure
that the direction notches are po-
sitioned correctly and the securing
clips are fixed properly.

Reconnect the connector.

Refit the protective cover.
3 - Side lights:
W 5 W.

Remove the protective cover, dis-
connect the connector and then re-
move the bulb and change it.

Put the connector back in place.

Reconnect the connector.

Refit the protective cover.
4 - Direction indicators:
PY 21 W (amber).

Turn the bulb holder a quarter turn
and remove it.

Change the bulb.
WARNING: RISK OF
ELECTROCUTION
Front lights
In the engine compartment, remove
the cover secured by one or two but-
terfly screws, a plastic retainer clip and
two quarter turn screws.
1 - Dipped beam headlamps:
H1-55 W or D2S-35 W xenon
bulb.
Xenon bulbs must be replaced by a
PEUGEOT dealer.
Amber coloured bulbs (direc-
tion indicators and side re-
peaters) must be replaced
with bulbs of identical specifi-
cation and colour.
5 - Front fog lamps:
H11-55 W.
Turn the wheels to full lock.
Access to the bulb is via the flap in the
front mud flap.
Contact a PEUGEOT dealer.
The headlamps are fitted with polycar-
bonate glass with a protective coating.
Do not clean them with a dry or abrasive
cloth, nor with a detergent or solvent
product.
Ensure that the liquid used to fill the
wash-wipe and headlamp wash reser-
voir is of good quality.
In certain climatic conditions
(low temperature, humidity),
condensation on the inside
surface of the headlamp glass
is normal; it disappears a few minutes
after the lights are switched on.

PEUGEOT 407 Specifications

General

Brand	PEUGEOT
Model	407
Category	Automobile
Language	English