164
!
Child safety
508_en_Chap06_securite-enfants_ed02-2014
Your vehicle has been approved in accordance
with the latest ISOFIX regulation s.
The seats, represented below, are fitted with
regulation ISOFIX mountings.
"ISOFIX" mountings
There are three rings for each seat.
- Two rings A, located between the vehicle
seat back and cushion, indicated by a
label.
This ISOFIX mounting system provides fast,
reliable and safe fitting of the child seat in your
vehicle.
The ISOFIX child seats are fitted with two
latches which are easily secured on the two
rings A.
Some also have an upper strap which is
attached to ring B.
Saloon
SW
The incorrect installation of a child seat
in a vehicle compromises the child's
protection in the event of an accident.
For information regarding the ISOFIX child
seats which can be installed in your vehicle,
refer to the table showing the locations for
installing ISOFIX child seats.
- A ring B, behind the seat, referred to as the
TOP TETHER for fixing the upper strap.
The TOP TETHER is used to secure the upper
strap of child seats that have one.
This arrangement reduces forward tipping of
the child seat in the event of a front impact.
To attach this strap, raise the vehicle seat's
head restraint then pass the hook between its
rods. Then fix the hook on ring B and tighten
the upper strap.
Follow strictly the instructions for
fitting child seats contained in their
manufacturer's installation guide.
To Next Page
Loading...
Need help?
General
