Adjustment
14 - 31
000 008 Speed for the "winding" function 500 2700 1500
This parameter is used to fix the speed
for the winding operation.
009 Via zero point to starting point after
end of sequence ON –OFF OFF
With this parameter it is possible to
choose that, after the end of the
sequence, the X-, Y-drive moves to the
seam starting point via the reference
initiators.
010 Via zero point to starting point after
number of program cycles ON –OFF OFF
Number of program cycles 1 - 100
With this parameter it is possible to
choose that, after a certain number of
program cycles, the X-, Y-drive moves
to the seam starting point via the
reference initiators.
011 Pedal mode 0 – 1 0
Switchover between level mode
(0) and flip flop mode (1).
012 Needle or balance wheel position in 0 - 360 11
degrees
013 NIS "needle in material" [°] 65 – 166 107
This parameter is used to set the NIS
signal. If the function is executed, the
position can be entered by turning the
balance wheel. If the position is altered,
the result is a change in the point of
time when the carriage is moved. The
access code is necessary for this
adjustment.
014 Thread trimming speed [min-1] 100 – 700 300
This parameter is used to fix the speed
for thread trimming.
015 Reduced current for stepping motors ON – OFF ON
The reduction function of the holding
current at rest with closed work clamp
is switched on or off.
016 Key tone ON – OFF ON
The key tone, as reaction to a key on
the control panel being pressed, is
switched on or off. The double tone
for incorrect inputs always remains
switched on.
Group Parameter Description Setting Set value
range
To Next Page
Loading...
Need help?
General
