Adjustment
14 - 6
TE
● Call up parameter "609".
Checking the "X-direction"
● Move along the maximum set sewing area size in "X-direction" by pressing the
corresponding plus/minus keys.
● If necessary adjust the position of work clamp 1 by entering a correction value "X"
with
the corresponding plus/minus keys
in "X-direction"
in accordance with the
requirement.
● Conclude the input.
When using the max. sewing area size (X=40mm, X =20 mm), the correction
value under parameter "609" must be set at "0".
To Next Page
Loading...
