2. Mounting the V-Belt
The machines ore shipped with the belt guard removed.
To mount the V-belt, lift the sewing head slightly and place the belt on the
machine
and
motor pulleys.
Slightly turn out screws
ol,
a2, a3, and a4, and push the two belt guard
sections together, holding them close to the machine so
that
the
above
screws
enter the appropriate slots in the back wall of the belt guard.
Fig. 2 R8608
To tighten the screws again, insert the screwdriver through openings
bl,
b2,
b3,
and
b4 (Fig. 2).
Both belt
guard
sections
ore
secured
to the vertical portion of the machine
arm
by inserting screw d (Fig. 1) through holes b5
and
c into screwhole dl
and
tightening it securely,
To Next Page
Loading...
