EasyManua.ls Logo

Pfister Ladera LF-048-LR User Manual

Pfister Ladera LF-048-LR
6 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
498830500
Dec 11, 2019
Installation Support • Soporte de Instalación • Support dInstallation
Installation Videos Available
Videos de instalación a disposición
Vidéos d’installation disponibles
Personal Assistance, Product Specs, &
“How-to” Questions:
Asistencia personal, especificaciones del
producto y preguntas sobre “cómo hacerlo”:
Aide personnelle, spécifications du produit
et questions « pratico-pratiques » :
1800PFAUCET (7328238)
pisterfaucets.com/support
pisterfaucets.com/videos
Required Tools
Herramientas necesarias
Outils nécessaires
Additional Helpful Tools
Otras herramientas útiles
Outils supplémentaires utiles
Parts in the Box
Piezas en la caja
Pièces dans la boîte
Copyright © 2019, Pister Inc.
4" Centerset Lavatory Faucet
Grifo central de 4 pulg. para el baño
Robinet pou lavabo centré de 4 po.
Adjustable Wrench
Llave ajustable
Clé à mollette
Safety Goggles
Gafas de seguridad
Lunettes de sûreté
Flashlight
Linterna
Lampe De Poche
Cloth
Paño
Chion
Bucket
Balde
Seau
WARNING / ADVERTENCIA / AVERTISSEMENT
Locate water supply inlets and shut of the water supply valves. These are usually
found under the sink or near the water meter. If you are replacing an existing faucet,
remove the old faucet from the sink and clean the sink surface thoroughly.
Ubique las entradas del suministro de agua y cierre las válvulas de suministro de agua.
Generalmente se encuentran debajo del fregadero o cerca del medidor de agua. Si se trata de
un reemplazo de grifo, quite el grifo viejo y limpie completamente la supericie del fregadero.
Recherchez les entrées d'approvisionnement et fermer leurs robinets. Ces robinets se
trouvent généralement sous l'évier ou près du compteur d’eau. Si vous remplacez un robinet
existant, retirez, le vieux robinet de l'évier et nettoyer soigneusement la surface de ce dernier.
Turn O Water Supply Cierre el suministro de agua Couper l’alimentation en eau
1
Quick Installation Guide
Guía de Instalación Rápida
Guide dInstallation Rapide
To reduce the risk of injury or property damage, read all instructions before installing product. Wear safety goggles. Product must be installed in
accordance with all state & local plumbing & building codes. Call a professional if you are uncertain about installing this product.
Para disminuir el riesgo de lesiones o daños a la propiedad, lea todas las instrucciones antes de instalar el producto. Utilice gafas de seguridad. El producto deberá
instalarse de acuerdo con la normativa de plomería y construcción estatal y local. Llame a un profesional si no está seguro sobre cómo instalar este producto.
Pour réduire le risque de blessures ou de dommages, lire toutes les instructions avant d’installer le produit. Porter des lunettes de sécurité. Le produit doit être
installé en conformité avec tous les codes de construction et de plomberie locaux et de l'état. Appelez un professionnel si vous n’êtes pas certain de la façon
d’installer ce produit.
Ladera
LF-048-LR
A
B
1256832
Cold
Fría
Froid
Hot
Caliente
Chaud
SAMPLE COPY
Question and Answer IconNeed help?

Do you have a question about the Pfister Ladera LF-048-LR and is the answer not in the manual?

Pfister Ladera LF-048-LR Specifications

General IconGeneral
BrandPfister
ModelLadera LF-048-LR
CategoryKitchen & Bath Fixtures
LanguageEnglish

Summary

Turn Off Water Supply

Install Faucet

Disassemble Faucet Components

Disassemble faucet components for installation, noting parts saved for later steps.

Position Faucet Spout Forward

Ensure the faucet spout is correctly oriented forward before proceeding with installation.

Secure Faucet

Hand Tighten Faucet Components

Manually tighten the faucet components securely to the sink surface.

Connect Water Supply Lines

Guide Water Lines and Flush

Guide water lines into bucket, turn on water, and flush lines for 30 seconds.

Turn Off Water Supply After Flushing

Close water supply valves after the flushing procedure.

Prepare and Install Drain

Disassemble and Prepare Drain Body

Disassemble drain components, avoid plumber's putty, and partially thread body.

Connect Drain and Tighten Nut

Connect the drain to the plumbing and firmly hand-tighten the securing nut.

Final Checks and Aerator Reinstallation

Remove and Turn On Water

Remove the aerator, turn on the water supply, and open the faucet slowly.

Run Water and Check for Leaks

Allow hot and cold water to run for 15 seconds each and check for leaks.

Reinstall Aerator

Reinstall the faucet aerator after confirming proper installation and checking for leaks.

Related product manuals