3)7*67$1'$5' 86$
3URFHGXUHVDWHQGRIZRU NDQGFOHDQLQJ
BBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBB
BBBBBBBBBBBBBBBBBBBBBBBBBBBBBBBB
________________________________________________________________________________________
- Insert the cleaning shaft (2) and the cleaner (1) with the scapers facing
downwards.
- The motor must be tilted into closed position again and the tilting flange latched.
- Take off mortar hose (only without pressure!)
- Press green button "ON", run approx. 5 to 10 sec until mixing tube is clean.
- Press red button "OFF", take out cleaner.
- Put in cleaned mixing shaft.
- Close motor hinged flange and lock with snap locks, connect 7 pole plug at motor
hinged flange.
For cleaning to take place, the hoses, including the mortar pressure manometer, are
connected to the water inlet valve with the transition adapter (in the tool kit). This
reduces wear on the pump. First, a water-soaked sponge ball must be pressed into
the hose inlet.
Then open the water valve until the sponge ball comes out of the end of the hose.
If there are hoses of different diameters the hoses should be cleaned separately with
sponge balls of the appropriate sizes.
If soiling is heavy, repeat this process.
To Next Page
Loading...
