15
3.3 Card Program
The MCU mode only allows the user to perform photometric measurement. If you want to perform
other measurements, please insert the required program card into the instrument.
We provide multiple program cards for your option, as well as other cell holders and software etc.
Please refer to the optional accessories for the detailed information of accessories.
Loading the program card
Make sure the instrument power is off. Insert the program card into the extended interface. Turn on the
instrument and perform initialization. Then, pressǏƷǐ and Ǐǐ to move the cursor to the option of
Card Program on the menu of Fig.3-11. And then press ǏENTERǐ to gain access to the required menu.
Refer to the instruction manual of the program card for the detailed information.
(Fig. 3-11)
Unloading the program card
Please turn off the instrument before taking out the card. Press the pushing bar above the slot to take
out the card.
Inputting the serial number
When the user uses the program card for the first time, the system will ask the user input the serial
number, which was given to the user by the manufactory when he bought the cards. The user also can
acquire the serial number by telephone. Please keep the serial number in an appropriate place.
If the user input the wrong number for more than 5 times, the system will return to the main menu.
The user should make sure the accuracy of the serial number, if not, please contact our service personnel.
The user is required to input the serial number when he uses the card for the first time, and needn’t to input
afterwards.
Do not insert or take out your program card when power on. Please keep your program card
appropriately.
The program card can only be inserted into the left extended slot, as shown in Fig. 3-11.
To Next Page
Loading...