To Next PageTo Next PageTo Previous PageTo Previous Page
Need help?Do you have a question about the Phanteks Enthoo EVOLV ITX and is the answer not in the manual?
General| Brand | Phanteks |
|---|---|
| Model | Enthoo EVOLV ITX |
| Category | Computer Accessories |
| Language | English |
Highlights the Enthoo EVOLV ITX case's features, compact size, budget-friendliness, metal exterior, tempered glass, and RGB integration.
Covers dimensions, form factor, materials, motherboard support, front I/O, and side window.
Details expansion slots and internal drive bays for 3.5" and 2.5" storage.
Lists fan sizes (120mm, 140mm, 200mm) supported in Front, Top, and Rear positions.
Specifies support for 120mm and 140mm radiators in Front, Top, and Rear locations.
Provides instructions for operating RGB lighting effects using the dedicated control button.
Steps for removing the right side panel by unscrewing captive screws.
Steps for removing the left side panel by unscrewing thumb screws.
Instructions on removing the front panel by pulling outward from the indicated area.
Guide for installing the motherboard with M3 screws, noting pre-installed standoffs.
Instructions on securely installing the power supply unit using the provided screws.
Steps to remove rear and front dust filters.
Guidance on cleaning dust filters with water and drying them before reinstallation.
Instructions for installing the radiator bracket, including alignment and securing with screws.
Steps for installing a 3.5" hard drive into the tray and locking it.
Guidance on aligning and screwing an SSD onto mounting holes.
Instructions on removing the HDD Cage by unscrewing the relevant screws.
Steps for sliding an SSD into the bracket and securing it from the side.
Instructions for aligning the bracket to the rubber and dropping it to lock.
Information on radiator bracket requirements and compatible radiator/fan sizes.
Specifies compatibility for 120mm radiators in Front, Rear, and Top positions.
Specifies compatibility for 140mm radiators in Front, Rear, and Top positions.
Details an optional accessory for mounting SSDs and 3.5" HDDs.
Information about an optional PWM hub upgrade accessory.
Details an optional accessory for mounting a pump bracket.
