Step 46
Mix up some epoxy and thoroughly cover
the base of the fin taking care not to get
epoxy on the servo or motor leads.
Step 47
Pulling the rudder servo lead down into the
duct, glue the fin in position ensuring that it
is square and perpendicular to the wing.
Step 48
Once the epoxy has cured, turn the model
over and attach a 300mm extension lead
to the rudder servo.
Step 49
Attach a length of double sided tape or
Velcro (hook and loop) to the electronic
speed controller.
Step 50
Secure the speed controller in its moulded
recess in the fuselage duct as shown.
To Next Page
Loading...