Step 56
Now apply epoxy to the inside of the pre-
painted, moulded intake lip as shown.
Step 57
Glue the intake lip moulding in position
making sure that any excess epoxy that
squeezes out is wiped off.
Step 58
Use small strips of masking tape to ensure
the moulded intake lip is held tightly to the
cowl as the epoxy cures.
Step 59
Mix up a small amount of epoxy and apply
to the inside of the moulded tailpipe.
Step 60
Slide the tailpipe in position and apply a
couple of strips of tape to secure it while
the epoxy cures.
IMPORTANT: IF YOU PLAN TO FIT THE
OPTIONAL VECTORED THRUST UNIT
DESCRIBED AT THE END OF THIS MANUAL
- PLEASE OMIT STEP 59 AND 60 AND DO
NOT FIT THE MOULDED TAILPIPE.
To Next Page
Loading...