Step 66
Repeat for the second elevon servo cover.
Step 67
Carefully trim the rudder servo cover to
clear the output horn. Now apply a smear
of epoxy to the perimeter of the cover.
Step 68
Glue the cover in position and hold or
apply a small strip of masking tape while
the epoxy cures.
Step 69
Trim the decals from decal sheet leaving a
small perimeter of clear around each.
Remove just one corner of the backing
paper and position the decal correctly.
Step 70
Carefully remove the remaining backing
paper while rubbing down the decal. Work
slowly to avoid any wrinkles.
To Next Page
Loading...