Step 71
Once applied, carefully cut through the
decal where the rudder separates from the
fin.
Step 72
Ensure that you don’t cut the hinge tape,
run a sharp knife through the decal when
the rudder hinges.
Step 73
Apply the main wing decal in the same
way buy only removing a corner of backing
paper to start with.
Step 74
Carefully remove the remaining backing
paper while rubbing down the decal. Work
slowly to avoid any wrinkles.
Step 75
Using a ruler and sharp knife, run a sharp
knife through the decal when the elevon
hinges. Work carefully to ensure that you
don’t cut the hinge tape.
To Next Page
Loading...