Step 81
Use a sharp knife to trim the decal flush
with the moulded nosecone.
Step 82
Starting from the intake lip, apply the
second black decal to the underside of the
cowl.
Step 83
Trim the rear of the decal flush with the
moulded tailpipe using a sharp knife.
Step 84
The underwing decals are best applied
singly, but you can mark their positions
with a pencil before separating them from
the decal sheet.
Step 85
Apply the second stripe ensuring that it
remains parallel to the first or use the pencil
guide marks you made. Rub down the
decal as you remove the backing paper.
To Next Page
Loading...