Step 86
Repeat the for the second wing panel
working from from the trailing to leading
edge.
Step 87
The final stripe is applied in the same way
with the backing paper removed carefully
as you work your way to the leading
edge.
Step 88
Again, using a ruler and sharp knife, run
through the decal when the elevon hinges
working carefully to ensure that you don’t
cut the hinge tape. Use the back of your
knife to smooth the cut decal down into the
hinge line.
Step 89
Apply a strip of double sided tape or
Velcro (hook and loop) to the rear of your
receiver.
Step 90
Attach the receiver to the base of the
fuselage towards the rear of the radio
bay.
To Next Page
Loading...