Step 91
Connect the two elevons, rudder and ESC’s
throttle lead to the appropriate receiver
channel outputs and tidy the wiring with
cable ties.
Step 92
Prepare the Li-Po battery mount by
removing the backing paper from the
Velcro (hook and loop) supplied.
Step 93
Attach it to the balsa battery mount,
pressing it firmly in position.
Step 94
Remove the second backing paper and
attach your Li-Po to the Velcro as shown.
Step 95
Use the supplied Velcro strap to give an
additional level of security to the battery
retention. This is a highly aerobatic model
and you don’t want to lose the battery in
flight!
To Next Page
Loading...