SD1411
13
Disc Repeat (RPT)
Press RPT (25) during disc play to continuously
repeat the selected track. “S--RPT” will appear
in the display. Press RPT again to stop
repeating. “S--RPT” will disappear from the
display, and regular play will resume. The
repeat function will also be canceled when
activating the scan or shuffle functions.
Disc Shuffle (RDM)
Press RDM (26) during disc play to play all
tracks on a CD in random, shuffled order. “S--
SHF” will appear in the display. Press RDM
again to stop random play. “S-SHF” will
disappear from the display and regular play will
resume. The shuffle function will also be
canceled when activating the scan or repeat
functions.
Disc Eject
Press the eject button (29) to stop CD play and
eject the disc. The unit will change to tuner or
AUX operation, depending on which mode was
in operation prior to disc play. If the disc is not
removed from the unit within 15 seconds, the
disc will be reloaded to prevent accidental
damage. Disc play can be resumed by pressing
MODE (2) to choose the CD player function.
CD Player Error Codes
If a problem should develop while operating the
CD player, an error code (ER-1, ER-2, etc.)
may appear on the display panel. This can
indicate a number of problems with the unit,
including a mechanical error or an error in the
microprocessor control of the player. If an error
code should appear, try ejecting and reloading
the disc into the player. While the disc is out of
the unit, make sure it is clean and undamaged,
and then load it correctly. If this does not solve
the problem, pressing the reset button (11) may
help, but will erase the time and preset memory.
If the suggested measures do not solve the
problem, contact an approved warranty station
near you for further assistance.
To Next Page
Loading...
Need help?
General
