EasyManua.ls Logo

Philco PSL 40F CUBE - Appliance Placement and Location; Electrical Connection

Philco PSL 40F CUBE
144 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Copyright © 2020, Fast ČR, a. s. Revision 04/2022
EN - 14
Positioning
Install this appliance at a location where the ambient temperature corresponds to the climate class indicated
on the rating plate of the appliance:
for refrigerating appliances with climate class:
- extended temperate: this refrigerating appliance is intended to be used at ambient temperatures ranging
from 10 °C to 32 °C; (SN)
- temperate: this refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C
to 32 °C;(N)
- subtropical: this refrigerating appliance is intended to be used at ambient temperatures ranging from 16
°C to 38 °C;(ST)
- tropical: this refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to
43 °C;(T)
Location
The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight
etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the
appliance is positioned below an overhanging wall unit, the minimum distance between the top of the
cabinet and the wall unit must be at least 50 mm. Ideally, however, the appliance should not be positioned
below overhanging wall units. Accurate leveling is ensured by one or more adjustable feet at the base of the
cabinet.
This refrigerating appliance is not intended to be used as a built-in appliance;
• Placetheappliancetoadryplacetoprotectisagainsthighhumidity.
• Keeptheapplianceprotectedagainstdirectsunlight,rainorfrost.Placetheappliancefurtherfromheat
sources,suchasstove,reorheatingelements.
Warning! It must be possible to disconnect the appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your
domestic power supply. The appliance must be earthed. The power supply cable plug is provided with a
contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a
separateearthincompliancewithcurrentregulations,consultingaqualiedelectrician.
The manufacturer declines all responsibility if the above safety precautions are not observed. This appliance
complies with the E. E. C. Directives.

Table of Contents

Related product manuals