EasyManua.ls Logo

Philips 107E7 - Page 72

Philips 107E7
79 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17” CDT Color Monitor 107E7
72
5. Mechanical
5.1 Cosmetic
Philips ID
5.2 Mechanical data files
ProE files required
5.3 Location of logo
Per Philips make-up sheet
5.4 Location of icons
Per Philips make-up sheet
5.5 Color for resin/paint
Per Philips make-up sheet
5.6 Resins
• RoHS requirements.
• WEEE requirements.
5.7 If paint is used
•
RoHS requirements.
•
WEEE requirements.
5.8 Plastic mold tooling
• Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines, gate
marks, ejector marks, etc.).
• Painting to cover up cosmetic defects due to molding is strongly discouraged.
5.9 Plastics flammability
• All Plastics expect Base / Pedestal to be Flame Retardant UL 94-V0 or Better (if monitor weighs less than 18kg;
UL94-V0 is OK).
•
Base / Pedestal to be Flame Retardant UL 94-HB.
•
All major plastic parts (bezel, back cover) need to be molded from same resin. Base / Pedestal otherwise
specified.