220CW8 LCD
Electrical instruction
19
Step 3: Closing the path that you want to install, then chose the
shortcut folder ,press “Install” button ,and it will perform
automatically.
Fig.3
Re-programming Analog DDC IC
Step 1: After initialize the alignment fixture, connecting all
cables. Be using VGA port from monitor.
Step 2: Connect the power code of monitor and power on it.
Step 3: Double check the TVI_TOOL icon
to run the TV_TOOL.exe.
Step 4: Click the OPEN icon at the main menu
to open the DDC files.
Fig. 4
Step 5: In the “Detailed Timings” BLOCK2 key in the monitor
serial number.
Fig. 5
Step 6: Press “WRITE TO IC ” button in the tool bar ,when the
DDC data download into the DDC IC, a dialog box will be
appeared automatically as shown in below photos.
Fig. 6
Step 7: Power off the monitor.
http://www.wjel.net
To Next Page
Loading...
