Philips 273E3LSW/93 - Page 69

Meridian 3
69
3.3.3 Software control functions via OSD / control adjustable functions:
ITEM
1 OSD DEFINITIONS
26'SURSRVDO
YBSSW
026'%XWWRQ
GHILQLWLRQB
Reset -
No: Exit
Yes: Auto adjustment for
displaying timing mode and
recall factory preset
2 OSD LANGUAGES
ʼnĺġůŦŸġŪŵŦŮġ
ŵųŢůŴŭŢŵŪŰůġŠġijııĹıĵIJ
26'B6WULQJB0B
[OV
9 LANGUAGES
3 OSD TREE
3+,/,36(26'
75(([OV
4 POWER ON LOGO
IJĺijıŹIJıĹıŠůŦŸį
ţŮű
Power On Logo: Power On
Æ Show up Philips logo 3
seconds
Æ Change to input signal.
This picture is reference only.
The official drawing will send
out by PM.
Horizontal scanning
Sync polarity : Positive or Negative
Scanning frequency : 30 – 83 K Hz
Vertical scanning
Sync polarity : Positive or Negative
Scanning frequency : 56 - 76 Hz
Power input connection
Power cord length : 1.5M
Power cord type : 3 leads power cord with protective earth plug.
Power management
The monitor must comply with the Microsoft On Now specification, and meet EPA requirements.
Mode HSYNC VSYNC Video Pwr-cons. Indication Rec. time
Power-On On On active <47W (typ.)
< 55W(max.)
EPA5.0<37.3
White LED --
Standby Off Off blanked <0.5W Blinking white LED
Period 3ec on, 3sec off
< 3 s
DC Power Off N/A < 0.5W LED Off
Power saving < 14 s
VGA Display identification
In accordance with VESA Display Channel Standard Ver.1.0 and DDC 2B capability