Philips 27E2F7901 - VESA Mounting Preparation

14
2.5 Remove the Base Assembly
for VESA Mounting
Before you start disassembling the
monitor base, please follow the
instructions below to avoid any possible
damage or injury.
1. Place the monitor face down on a
smooth surface. Pay attention not to
scratch or damage the screen.
2. Whilekeepingthereleasebutton
pressed,tiltthestandandslideit
out.
1
2
Note
This monitor accepts a 100mm x 100mm
VESA-Compliant mounting interface.
VESA Mounting Screw M4. Always
contact manufacturer for wall-mount
installation.
100mm
100mm
Note
Please purchase the appropriate wall
mount; otherwise the distance between
the back-plug-in signal cable and the wall
would be too short.
-5°
0° 90°
* Display design may dier from those
illustrated.
Warning
• To avoid potential creen damage,
such as panel peeling, ensure that the
monitor does not tilt downward by
more than -5 degrees.
• Do not press the screen while
adjusting the angle of the monitor.
Grasp only the bezel.