[f ),our cable signal uses a cable
I box or deeoderJbllow the easy
steps below to complete the connec-
tion.
Cable Box (w/RF In/Outputs):
This connection will be mono.
Connect the Cable Companysupplied cable to the signal
iN(put) plug on the back of the
Cable Box.
Using a separate round coaxial
cable, connect one end to the
OUT(put) (TO TV)plug on the
back of the Cable Box.
Connect the other end of the
round coaxial cable to the 75£2
input on the back of the televi-
sion. Screw it down finger tight.
NOTE: If applicable, set the OUT-
PUT CHANNEL SWITCH on the
back of the cable box to CH 3 or 4.
Tur_e the TV to the same chanrtel and
change channels at the cable box. In
some cases, the cable box will auto-
matically tune to either channel 3 or 4,
change channels until the picture
appears.
Cable Box (whkudio/Video
Outputs):
This connection will supply Stereo
sotw_d.
Connect the Cable Company
supplied cable to the cable slg-
nallN(put) plug on the back of
the Cable Box.
Using a RCA type Video Cable,
connect one end of the cable to
the Video (or ANT, your cable
box may be labeled-di{]_rently)
Out ]a_:k on the cable box_ and
the other end to the AVI Video
input on the TV_
Connect one end of the Audio
Left and Right Cable to the left
and right Audio Out L & R
jacks on the cable box. Connect
the other end to the AVI Audio L
& R Input jacks on the TM
NOTE: Use the AV button on the TV
remote control to tune to the AVI
channel for the cable box signal. Once
tuned change channels at the cable
box, not the te ev s on.
Cable Box (wfRF h,dOutputs):
Cable Signal IN from the
Cable Company
Round 750. J_ck Panel Back of TV
Coaxial Cable
Cable Box (w/Audio/Video Outputs):
C_ble Signal IN
Audio Cables
L (White) & R (Red) V_deo Cabte
(Yellow)
To Next Page