Philips 3000i Series - Turning on and off; Changing the Mode Setting

12 EN
Turning on and o
Note:
• For optimum purication performance, close doors and windows�
• Keep curtains away from the air inlet or air outlet�
1 Put the plug of the air purier in the power socket�
2 Touch to switch on the air purier�
» The air purier beeps�
» The " " displays on the screen during warming
up� Then the air purier shows the IAI/PM2�5/
Gas level after measuring the air quality�
» The air purier operates in the auto mode with
IAI displayed on the screen�
3 Touch and hold the button for 3 seconds to
switch o the air purier�
Note: If the air purier stays connected to the electrical outlet after turning
OFF, the air purier will operate under the previous settings when turned ON
again�
Changing the mode setting
You can choose Auto mode, Turbo mode or the Sleep mode by touching the
button�
Auto mode ( ): In Auto mode, the dual-sensor sense the air quality
in real-time and the appliance automatically adjusts the fan speed in
accordance with the ambient air quality, the control panel can automatically
adjust display screen brightness according to the ambient light�
Turbo mode ( ): In Turbo mode, the air purier operates on the highest
speed�
Sleep mode ( ): In Sleep mode, the air purier operates quietly at a low
speed� After 3 seconds, the screen lights o�