Philips 32E1N3100LA - Page 10

8
Note
• MPRT: To reduce motion blur, LED
backlight will strobe synchronously
with screen refresh, which may cause
noticeable brightness change.
• 75Hz refresh rate or higher is re-
quired for MPRT.
• Adaptive Sync and MPRT cannot be
enabled simultaneously.
• MPRT is to adjust brightness for blur
reduction, so cannot adjust bright-
ness while MPRT is turned on.
• MPRT is gaming-optimized mode.
Turn on MPRT may cause noticeable
screen ickering. It is recommended
to turn o when you are not using
the gaming function.
3
Resolution notication
This monitor is designed for optimal
performance at its native resolution,
1920 x 1080. When the monitor is
powered on at a dierent resolution, an
alert is displayed on screen: Use 1920 x
1080 for best results.
Display of the native resolution alert can
be switched o from Setup in the OSD
(On Screen Display) menu.
4
Physical Function
Tilt
20°
-5°
Warning
• To avoid potential screen damage,
such as panel peeling, ensure that
the monitor does not tilt downward
by more than -5 degrees.
• Do not press the screen while
adjusting the angle of the monitor.
Grasp only the bezel.