Introduction: Digital TV
EN
8
Note: if the TV has already been installed before and/or you
want to change the First time installation settings, proceed
with Use of the TV menu settings, p. 13.
Next to analogue broadcast reception, your TV has a built-in TV
tuner which receives, decodes and displays digital terrestrial
signals.
Digital TV and radio channels are only available and reproduced:
- when Digital Video Broadcasting Terrestrial (DVB-T) is
applicable in your local area;
- and if DVB-T signal is supported by your TV for the country
you live in. See www.philips.com/support for the list of
supported countries.
Switch the TV on
< Press the power switch B at the side of the TV.
> An indicator on the front of the TV lights up and the
screen comes on.
< If the TV is in standby mode, press the
-P+ keys or the B
key on the remote control.
Note: the first time (and only the first time) you switch
on your TV, you see a Welcome screen followed by the
installation procedure. See First time installation, p. 9.
First time installation
The installation procedure consists of a series of screens that
will guide you through the installation of your TV.
Follow the instructions on screen.
To Next Page
Loading...
