• (Options): Displays the menu of the
connected device. When
is pressed,
the TV menu is displayed.
•
(Standby): Press to enable one-touch
standby. This switches the TV and the
connected device to standby.
Other EasyLink buttons are available via On-
Screen Remote Control (OSRC).
To access the OSRC
1. While watching a connected device, press
.
2. Select [Show remote control], then press
OK.
3. Use the Navigation buttons and OK to
select and use an on-screen button.
4. Press
to exit.
Configure TV speakers
NonPubli sh
You usually connect the TV to an HDMI-
CEC compliant device such as a HTS using
both an HDMI cable for video and a digital
audio cable for audio. You can output TV
audio through the HDMI cable solely,
provided both the TV and device are HDMI
ARC compliant (see Connect the TV > Use
Philips EasyLink > Use HDMI ARC).
Configure TV speakers
1. Press
.
2. Select [Setup] > [Advanced TV settings]
> [EasyLink] > [TV speakers].
3. Select one of the following options, then
press OK:
• [Off]: Turn off TV speakers.
• [On]: Turn on TV speakers.
• [EasyLink]: TV audio continues to be
streamed through the TV speakers.
Switch the TV audio to the connected
HDMI-CEC audio device through the
experience menu.
• [EasyLink autostart]: Turn off TV
speakers automatically and streams TV
audio to the connected HDMI-CEC
audio device.
Switch TV audio in experience menu
If [EasyLink] or [EasyLink autostart] are
selected, access the experience menu to
switch the TV audio.
1. While watching TV, press
.
2. Select [Speakers], then press OK.
3. Select one of the following, then press
OK:
• [TV]: On by default. Streams TV audio
through TV speakers until the
connected HDMI-CEC audio device
switches to system audio control.
Thereafter, TV audio is streamed
through the connected device.
• [Amplifier]: Streams audio through the
connected HDMI-CEC device. If system
audio mode is not enabled on the
device, audio will continue to stream
from TV speakers if [EasyLink] was
selected. If [EasyLink autostart] was
enabled, the TV prompts the
connected device to switch to system
audio mode.
To Next Page
Loading...
