Mechanical Instructions
EN 19TPN10.1E LA 4.
2013-Oct-18
back to
div. table
4.2 Service Positions
For easy servicing of a TV set, the set should be put face down
on a soft flat surface, foam buffers or other specific workshop
tools. Ensure that a stable situation is created to perform
measurements and alignments. When using foam bars take
care that these always support the cabinet and never only the
display. Caution: Failure to follow these guidelines can
seriously damage the display!
Ensure that ESD safe measures are taken.
4.3 Assembly/Panel Removal (for 32" & 39")
Instructions below apply to the 32PFL3168T/60, but will be
similar for other series models.
4.3.1 Rear Cover
Refer to Figure 4-8
for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1. Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set. Then remove the fixation
screws [2], [3]that secure the rear cover. Refer to
Figure 4-8
for details.
2. Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
Figure 4-8 Rear cover removal [1]
19530_106_130723.eps
130723
1
M4 × 10
Q3 × 8
1
1
1
1
2
2
2
2
2
2
2
M3 × 6
3
3
3
To Next Page
Loading...
