Mechanical Instructions
EN 21TPN10.1E LA 4.
2013-Oct-18
back to
div. table
Figure 4-10 Speakers removal
4.3.3 Small Signal Board (SSB) + PSU combination panel
Refer to Figure 4-11
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB + PSU combination panel.
1. Release the clips from the LVDS connector that connect
with the SSB + PSU combination panel [1].
Caution: be careful, as these are very fragile connectors!
2. Unplug all other connectors [2] , [3].
3. Remove all the fixation screws from the SSB + PSU
combination panel [4].
4. The SSB + PSU combination panel can now be shifted
from side connector cover, then lifted and taken out of the
I/O bracket. Refer to Figure 4-11
for details.
Figure 4-11 SSB + PSU combination panel removal
4.3.4 Stand bracket
1. Remove all fixation screws of the bracket.
2. Lift the bracket from the set.
4.3.5 Control Board IR/LED Panel
1. Remove the stand bracket, as described earlier.
19530_110_130723.eps
130723
1
1
1
1
3
2
3
19530_112_130723.eps
130723
2
3
1
4
4
4
4
To Next Page
Loading...
